The app measures reporting, not production
A solar monitoring system is a data pipeline, not a production meter. The inverters or microinverters generate power independently of whether the gateway can reach the internet. When the pipeline breaks, the chart stops while the array keeps working.
That distinction decides whether this is an emergency. A homeowner with a working array and a broken app has a nuisance. A homeowner with a broken array and a working app has a revenue problem that the app may already be showing.
Read the symptom before assuming a failure.
| What you see | What it usually means | What would prove it |
|---|---|---|
| Flat line since a specific date | Gateway lost internet or power | Check the router and the gateway's status light |
| All devices missing | Gateway or communications fault, not twenty simultaneous panel failures | Look for a gateway-level alert |
| One or two devices missing | Individual device or branch-circuit communication issue | Note which devices and for how long |
| Data present but low | A production question, not a reporting question | Compare against a clear-day history |
| History missing after a long outage | Stored data still uploading | Wait, then check again |
What a homeowner can check without opening anything
- Confirm the home internet is working, and note whether the router, modem, Wi-Fi name or password changed recently.
- Note the exact date and time the data stopped, because it often lines up with a router swap, a power outage, or a provider change.
- Check whether the app shows a gateway-level alert separate from device-level alerts.
- Photograph the inverter or gateway indicator lights without removing covers.
- Look at the utility meter and compare a recent sunny day against the same day in the app.
How to prove production is still happening
The fastest independent check is the utility meter, not the app. Read the meter during a sunny midday window on a day with no large loads running, and compare it against a day you know was working. A system that is producing will show export or a reduced import even while the app is dark.
The second check is the utility bill. Compare the current billing period against the same period last year and against the month before the monitoring stopped. A real production failure usually shows up as a jump in consumption charges within one billing cycle.
- Meter: compare two sunny middays, one before and one after the data stopped.
- Bill: compare the current period against the same period a year earlier.
- Inverter display, if it has one: record any code or status it shows.
- Photos: capture the app screen, the last-updated timestamp, and any alert wording.
When it is not just the app
Two patterns make a genuine production fault more likely than a communications problem. The first is a system that was reporting normally and now reports normally again but at a fraction of its previous output on comparable sunny days. The second is a bill that rose sharply in the same period the data went quiet.
Both point at equipment rather than connectivity, and both are worth a diagnostic visit with the evidence you collected. A service provider can measure at the inverter and at the array, which no app can do.
What to bring to a service review
- The monitoring platform, site ID if shown, and the equipment brand and model.
- The exact date the data stopped, and anything that changed that week.
- Screenshots of the app, including the last-updated time and any alerts.
- Two utility bills: the most recent, and the same period a year earlier.
- The original installation agreement and any warranty documents you still hold.