Source-linked homeowner guide8 min read

Solar System Producing Zero? The Diagnostic Order That Saves a Service Call

The array is making nothing at midday with clear sky. There are only a handful of reasons, and they run from a switch to a dead inverter.

Last updated:

Reviewed against manufacturer and public agency documentation in November 2026. Educational information, not tax, legal, engineering, electrical, or utility advice.

Work from the outside in

A solar system has a small number of places where production can be interrupted. Checking them in physical order, from the meter toward the roof, means you stop at the first break instead of guessing at the most expensive one.

Each step eliminates a whole category of cause.

OrderWhat to checkIf it is the cause
1Utility service and meter statusUtility-side outage or a disconnected interconnection
2AC disconnect at the wallSomeone turned it off, often during other work
3Solar breaker in the main panelTripped breaker, sometimes from a surge
4Inverter display or indicator lightsInverter fault, which the display usually names
5Monitoring platform for device-level statusArray-side or communications fault

The first three checks are homeowner-safe

  • Confirm the home has utility power at all. A whole-home outage looks identical to a solar outage in an app.
  • Find the AC disconnect, usually a labelled switch near the meter or the inverter. Note whether it is on.
  • Look at the solar breaker in the main panel. A tripped breaker sits between on and off rather than fully to one side.
  • Do not reset a breaker more than once. A breaker that trips again is reporting a fault, not a nuisance.

Read the inverter before you call

Most inverters show a status code or a light pattern that names the fault. Photograph it. That single image shortens the visit and sometimes avoids it, because the provider can arrive with the right part.

A dark inverter with utility power present is different from an inverter showing a fault code. The first points at supply or the unit itself; the second tells you what the unit thinks is wrong.

Shapes of inverter evidence, and what each implies.

EvidenceImpliesNext step
No lights, no display, AC presentSupply-side or unit failureLicensed diagnostic
Fault code on displayNamed fault, often specificRecord the code, then book
Normal display, zero productionArray-side or measurement issueCompare device-level data
Normal display, production normalMonitoring or billing questionRecheck the app and the bill

When the inverter is fine and the array is not

If the inverter reports a healthy DC input but no output, the problem is on the supply or grid side. If it reports low or zero DC input on a sunny day, the array side is implicated: a string fault, a failed device, an open connection, or a ground fault.

Those conditions are diagnosed with a meter at the array. They are not homeowner checks, because the test points are energised and often on the roof.

What to send so the visit is short

  • Photograph the inverter display, the AC disconnect, and the main panel breaker positions.
  • Note the date and time production stopped, and whether anything happened that day.
  • Confirm whether the utility had an outage or a meter change.
  • Send the equipment brand, model, and system age.
  • Attach the monitoring screenshot showing the last producing day.

Frequently asked questions

Yes. The solar feed has its own breaker in the main panel, and if it trips the inverters shut down by design. Resetting once is reasonable. A breaker that trips again is reporting a fault and needs a licensed look.

Official sources and verification

Review current utility, tax, and licensing requirements directly with the responsible agency before making a property or contract decision.

Property-specific next step

Request Troubleshooting

Send the inverter photo, the breaker positions and the last producing day. We can review the request and check whether a licensed service partner covers your equipment.

Palm Beach Solar plans and coordinates the project. The selected licensed installation or service partner evaluates, quotes, and performs work under its own contract, licensing, and warranty terms.